IO-Compress-Lzf Version 2.034 2nd May 2011 Copyright (c) 2005-2011 Paul Marquess. All rights reserved. This program is free software; you can redistribute it and/or modify it under the same terms as Perl itself. DESCRIPTION ----------- This module provides a Perl interface to allow reading and writing of lzf files/buffers. PREREQUISITES ------------- Before you can build IO-Compress-Lzf you need to have the following installed on your system: * Perl 5.004 or better. * Compress::LZF * IO::Compress::Base BUILDING THE MODULE ------------------- Assuming you have met all the prerequisites, the module can now be built using this sequence of commands: perl Makefile.PL make make test INSTALLATION ------------ To install IO-Compress-Lzf, run the command below: make install TROUBLESHOOTING --------------- FEEDBACK -------- How to report a problem with IO-Compress-Lzf. To help me help you, I need all of the following information: 1. The Versions of everything relevant. This includes: a. The *complete* output from running this perl -V Do not edit the output in any way. Note, I want you to run "perl -V" and NOT "perl -v". If your perl does not understand the "-V" option it is too old. This module needs Perl version 5.004 or better. b. The version of IO-Compress-Lzf you have. If you have successfully installed IO-Compress-Lzf, this one-liner will tell you: perl -MIO::Compress::Lzf -e 'print qq[ver $IO::Compress::Lzf::VERSION\n]' If you are running windows use this perl -MIO::Compress::Lzf -e "print qq[ver $IO::Compress::Lzf::VERSION\n]" If you haven't installed IO-Compress-Lzf then search IO::Compress::Lzf.pm for a line like this: $VERSION = "2.034" ; 2. If you are having problems building IO-Compress-Lzf, send me a complete log of what happened. Start by unpacking the IO-Compress-Lzf module into a fresh directory and keep a log of all the steps [edit config.in, if necessary] perl Makefile.PL make make test TEST_VERBOSE=1 Paul Marquess